BDS 6 Inch Lift Kit Dodge Ram 1500 (09-11) 4WD (622H)

1. These trucks can vary from 1" to 3" tail high from the factory. Be sure to measure your vehicle before ordering. Part numbers 022209, 022309 and 022509 can all be substituted to achieve the desired stance. 2. The Rack & Pinion steering system is extremely sensitive to an out of round or out of balance tire/wheel combination. As you increase the tire diameter and/or decrease the wheel backspacing the more sensitive the system becomes and can cause minor steering wheel shimmy. 3. Not recommended for AWD models. 4. Stock 17" and 18" wheels cannot be reinstalled. Stock 20" wheels can be reinstalled with factory tires. 5. TRX models will achieve approximately 1" additional lift. This lift is not recommended for use on the TRX models due to possible CV shaft vibration caused by the additional lift. Instead, consider our 4" lift system for 5" of lift or replace the TRX struts with standard struts for use with this system. 6. This kit is FMVSS No.126 Compliant The NHTSA's Federal Motor Vehicle Safety Standard (FMVSS) No.126 requires all new passenger vehicles to include Electronic Stability Control (ESC) systems that meet certain standards that can be tested through a comprehensive series of evasive maneuvers. Aftermarket products must meet these standards as well. BDS Suspension is leading the industry by independently testing all suspension kits to verify our kits are fully compliant with the stability control system requirements set by Federal Motor Vehicle Safety Standard (FMVSS) No. 126.

Tire & Wheel Combinations
37" x 13.50" w/17 x 9 and 4-1/2" back spacing
37" x 13.50" w/18 or 20 x 9 and 5" back spacing
*Trimming may be required*

Est. Installation: 10 hours
Difficulty Level (easy 1 - 5 complicated): 4