BDS Suspension 6" Suspension Lift Kit System for 2009-2013 Ford F150 4WD pickup trucks. View Four Wheeler installation article This system includes CNC machined steering knuckles to return your vehicle's steering to factory geometry. One piece front & rear High Clearance crossmembers increase rigidity for long term performance as well as dramatically increase ground clearance. A 1/4" thick steel differential skid plate and is included to ensure off road protection. New custom valved off road struts are supplied that are designed to handle the increased load of an oversized tire while still maintaining the OE ride quality. The rear is lifted with a new block and includes a new offset spring plate to center the rear axle and give your 37's plenty of room.
Prop 65 Notice
ATTENTION STATE OF CALIFORNIA CONSUMERS: *WARNING* Cancer and reproductive harm-www.p65warnings.ca.gov
Important Notes
1. Strut compressor required for installation. 2. Requires frame bracket modification and welding. 3. 18" wheels with 5-5.5" total backspacing should be test fir prior to mounting tire to ensure proper clearance to BDS steering knuckle. 4. 18" or larger diameter wheels required. Stock 17" & 18" wheels cannot be reinstalled. Stock 20" wheels can be used with up to a 305/60-20 tires. 5. E-brake bracket required for factory powersteps (123018) Block kits replace factory 1-1/4" block. 6. For a level to tail low appearance use #023415 with Kit#598H or use #013429 with Kit#573H. 7. Models with a 2-piece rear driveshaft may require carrier bearing drop shim kit #123402 8. Will fit EcoBoost models. 9. Models equipped with AWD/ Auto 4wd may require front driveshaft replacement. 10. This kit is FMVSS No.126 Compliant The NHTSA's Federal Motor Vehicle Safety Standard (FMVSS) No.126 requires all new passenger vehicles to include Electronic Stability Control (ESC) systems that meet certain standards that can be tested through a comprehensive series of evasive maneuvers. Aftermarket products must meet these standards as well. BDS Suspension is leading the industry by independently testing all suspension kits to verify our kits are fully compliant with the stability control system requirements set by Federal Motor Vehicle Safety Standard (FMVSS) No. 126.
Tire & Wheel Combinations
37" x 12.50" w/18 x 9 and 5" back spacing
35" x 12.50" w/18 x 9 and 5" back spacing
20 x 9 w/37x12.50 and 5-5.5" back spacing
*Trimming may be required*
Total Reviews (0)
Write the First Review!