ZONE 6" Lift Kit w/ Nitro Shocks 2009-2013 RAM 2500 w/ 3.5" Axle *GAS* (ZOND39N)

Will work with Power Wagon models with the addition of sway bar link kit D5301. Power Wagon models came factory with a 2” taller ride height, so net lift gain will be 4” over stock.
Check Rear Axle Diameter: This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
Driveline Notice: Although rare, if you experience front driveline vibration, install the optional transfer case indexing ring.
Fitment: This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
Gas models may require modification to the front exhaust crossover pipe on driver side when using the transfer case indexing ring.
Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
Wheels / Tires: Adding larger-than-stock wheels? Add front bumper spacers to your kit for additional clearance as some wheel / tire combos may not fully clear the bumper’s stock location.
Works on 2013 2500 with 4 link front suspension only. Will not fit 1 Ton Trucks.